Revolver 'Smith in Central AL?

[kwb377]

Any recommended revolver 'smiths in B'ham area (or within reasonable driving distance)?

Recently bought an older N-Frame that I've discovered has hammer push off. Pulled the hammer and trigger and it looks like someone went crazy with a Dremel and polished the sear shelf on the hammer and rounded it off. I've ordered a "new" (well, less used than mine ) hammer and will probably need the sear angles cut on the replacement hammer and current trigger.

I could buy a stone and WECSOG it myself (and ruin it), but hoping to find an experienced revolver 'smith rather than just someone who "works" on guns.

Thanks!

 

[Bama55]

I'm not a gunsmith, but I have replaced a few hammers, triggers, etc. on mine. Most of the time they were drop-in. As far as stoning the angles, all you do on S&W trigger/hammer is lightly stone to remove burrs. Too much and you remove the case hardening and the angles will round off fairly quickly.
I wish you had posted you needed a hammer and trigger, I have several spares of each.